The Falcon’s state-of-the-art microprocessor and flat antenna provide the ability to disregard pedestrians
and only allow large masses (such as trucks and forklifts)
to be detected-even at lower mounting heights.

With more standard features than any other loop detector
on the market, the Matrix2-S has the flexibility, compatibility
and performance to maximize
productivity and safety on your site.

Ideal for 1-3/4 to 2 inch thick doors. The flexible flaps wrap around the bottom of the door for direct mounting. Try aluminum or wood trim to give a "finished look".

The ME123 is designed for use on 1-1/2 to 2 inch thick doors and gates. To install, slide the edge into the mounting channel and then mount the assembly to the door.

The MGO20 is designed for use on doors and gates up to 1-1/2 inches thick. To install, simply attach the rigid PVC or aluminum mounting channel and slide sensor into the channel. This edge cannot be bent or folded.

The Patriot Telescopic Non-Contact SensingEdge is manufactured to work with Rapid Roll and Sectional Doors. The system consists of a Control Unit, Emitter Eye and a Receiver Eye which simply mounts into a rigid steel, spring loaded retracting arm. The arms are mounted to the bottom of the door and extend below the leading edge of the door, thus providing an invisible infrared beam of protection. If the beam is blocked by an object or person below the door, the control unit signals the door operator to stop and/or reverse.

The Patriot Z-Flap Non-Contact SensingEdge is manufactured to work with Rolling Steel and Sectional Doors. The system consists of a Control Unit, Emitter Eye and a Receiver Eye which simply mounts into a flexible molded Z-Flap mounting bracket made of Dupont Hytrel®. The Z-Flaps are mounted to the bottom of the door and extend below the leading edge of the door, thus providing an invisible infrared beam of protection. If the beam is blocked by an object or person below the door, the control unit signals the door operator to stop and/or reverse.

The Miller Edge Model MWCK02 gate and door edge transmitter and receiver kit is designed to provide a fully reliable, self-checking communication between the 4-wire SensingEdge and the door or gate motor operator. When the SensingEdge detects an obstruction, a fault condition is communicated to the transmitter and the receiver. The signal is then passed on to the motor operator to control the motion of the door or gate.

Alumaglas® Contact Elements cover the entire surface virtually eliminating any dead zones in the active surface. Alumaglas® will not rust or dent. It is completely flexible enabling it to bounce back from impacts without dents which could damage other rigid contact elements.

The Miller Edge Model MWT02 gate and door edge wireless transmitter is designed to eliminate the need for Coil Cords or Retracting Reels.

The Miller Edge Model MWTA02 gate and door edge transmitter is designed to provide obstacle sensing protection for a variety of motorized gates and doors. The Model MWTA02 is available with an Audible Alarm feature that activates when the battery has only 25% of its life remaining, indicating the battery should be replaced.

Both the Miller Edge receiver and transmitters are designed to have several selectable options not found on other radio controls. Simply select these options with the convenient dip switches and wire harness. The receiver will operate on either 12 or 24 volt AC or DC and is capable of sending a pulse or continuous signal.

Both the Miller Edge receiver and transmitters are designed to have several selectable options not found on other radio controls. Simply select these options with the convenient dip switches and wire harness. The 3-channel receiver will operate on either 12 or 24 volt AC or DC and is capable of sending a pulse or continuous signal.