The High Mounting Eagle Motion Detector (PN: 10EAGLE1HM) nd technology combined with digital processing to assure a
sharp, stable activation pattern with outstanding adjustability.
The Falcon’s state-of-the-art microprocessor and flat
antenna provide the ability to disregard pedestrians
and only allow large masses (such as trucks and forklifts)
to be detected-even at lower mounting heights.
The FlexIR is a light beam
flexible mounting bracket
that prevents BEA's Microcell system
from damage when installed away
from the door Jamb surface.
With more standard features
than any other loop detector
on the market, the Matrix2-S
has the flexibility, compatibility
and performance to maximize
productivity and safety
on your site.
The
ME120 is designed for
use on doors and gates
up to 1-1/2 inches
thick. To install,
simply attach the rigid
PVC or aluminum mounting
channel and slide sensor
into the channel.
The
ME123 is designed for
use on 1-1/2 to 2 inch
thick doors and gates.
To install;
slide the edge into the mounting
channel and then mount
the assembly to the
door.
The
MGO20 is designed for
use on doors and gates
up to 1-1/2 inches
thick. To install,
simply attach the rigid
PVC or aluminum mounting
channel and slide sensor
into the channel. This
edge cannot be bent
or folded.
The Miller Edge Model MWT02 gate
and door edge transmitter is designed to provide
obstacle sensing protection for a variety of motorized
gates and doors.
The Miller Edge Model MWTA02 gate
and door edge transmitter is designed to provide
obstacle sensing protection for a variety of motorized
gates and doors. The Model MWTA02 is available with
an Audible Alarm feature that activates when the
battery has only 25% of its life remaining, indicating
the battery should be replaced.
Both the Miller Edge receiver and
transmitters are designed to have several selectable
options not found on other radio controls. Simply
select these options with the convenient dip switches
and wire harness. The receiver will operate on either
12 or 24 volt AC or DC and is capable of sending
a pulse or continuous signal.
Both the Miller Edge receiver and
transmitters are designed
to have several selectable
options not found on
other radio controls.
Simply select these
options with the convenient
dip switches and wire
harness. The 3-channel
receiver will operate
on either 12 or 24 volt
AC or DC and is capable
of sending a pulse or
continuous signal.
The
Miller Edge Model MWCK02
gate and door edge
transmitter and receiver
kit, is designed to
provide a fully reliable,
self checking communication
between the 4-wire
SensingEdge and the
door or gate motor
operator. When the
SensingEdge detects
an obstruction, a fault
condition is communicated
to the transmitter
and the receiver.
The signal is then
passed on to the motor
operator to control
the motion of the
door or gate.
