PHT1EE*

Invisi-Guard™ PHT1EE Thru-Beam Photo Eye for Solar Powered Swing Gate Operators

*Invisi-Guard PHT models have been recently discontinued but, are still supported.
PHT models are now replaced by IG2.

Use two PHT1EE on swing gates so that both sides are guarded: install the 1st inside the area and the 2nd outside the area. As vehicles approach from either direction, the beam of light is interrupted signaling the gate arm to reverse.

PHTEE is energy efficient. Drawing just 6 Milli-Amps of power. It’s ideal for
use with solar powered gate operators.

PHT1EE includes two independently housed units: a battery powered infrared emitter and a receiver that wires directly to your controls. The battery-powered emitter saves time and money by eliminating the need to saw concrete or run
wire across the opening. The built-in audible low battery alarm alerts users when
it is time to replace batteries.

To provide your customer with an ideal solution, add UL325 tested gate
edge sensor to the gate itself.

Safety Standards and Codes for Motorized Gates:

Miller Edge offers a convenient guide to help you comply with the ANSI/UL325 standard for gate entrapment protection devices. To request a printed copy
of this guide, please email info@milleredge.com.

Before designing or motorizing any gate, be sure to read and understand the
ASTM-F2200 standard for gate construction.

Since 2009, the International Building Code (IBC-2009) has required compliance
with the current UL325 safety standard.